I-Wave Accessories

Freeze (Air Temperature) Sensor
178PA28A

Add the Intermatic Freeze or Air Temperature Sensor (178PA28A) to installations where below-freezing outdoor temperatures are a concern. The sensor is designed to protect the pool and spa equipment and plumbing against freeze damage. The sensor plugs into the circuit board on the back of the P1353ME and turns ON the filter pump when air temperature drops below the programmed temperature. The freeze programming mode will not appear unless the sensor is plugged into the clock.

Transceiver Repeater Module
HA04C

The Transceiver Repeater Module (HA04C) ensures that no problems in reception occur between the Hand Held Controller(s) (PE950) and the Panel-Mounted Transceiver (PE650). Reception is affected by distance (about 100 feet, direct line of sight) and by physical obstacles (like brick walls or structures). However, by plugging in a Transceiver Repeater Module where necessary, long distances or physical obstructions can be overcome.

Documentation

35-ft. Antenna Extension Cable Assembly
PA121

When a structure impedes transmission between the Panel-Mounted Transceiver (PE650) and Handheld Transceiver(s) (PE950), you can use the 35-ft. Antenna Extension Cable Assembly (PA121) to relocate the antenna from the Panel-Mounted Transceiver to the area of operation, ensuring that communication between the Hand-Held unit and the control center is successful.

Documentation

Water Temperature Sensor
PA122

The Intermatic Water Temperature Sensor (PA122) installs in the inlet side of the heater and monitors both pool and spa water temperature, depending on the position of the diverter valves. Installation is necessary for the thermostatic control to work. The sensor plugs into the Panel Mounted Transceiver (PE650) and the water temperature is displayed on the Hand-Held Transceiver (PE950).

Documentation

Home | Privacy Policy
© Intermatic, Inc. 2009. All Rights Reserved.